LockBox 2

Some years ago the old TurboPower LockBox 2 component has been maintained in a way that it is not backward compatible. That’s why it got the new version number 3.

If you have old code that uses LockBox 2 and should be moved to XE6 you have a problem. LockBox 3 is completely different to LockBox 2. You have to change your code or you need a LockBox 2 version for XE6.

That’s what happened to me this week. And Now I have a XE6 compatible version of LockBox 2. If someone is interested then send me an email and I will publish it.

This entry was posted in Delphi, RAD Studio XE6, SourceForge, Third Party Components, TurboPower, Uncategorized. Bookmark the permalink.

7 Responses to LockBox 2

  1. Lubos says:

    Hi ROman,

     

    could you please send me the Lockbox2 version?

     

    Thanks

     

    ::L

  2. Alan Sisson says:

    Hi Roman,

    I would be interested in getting LockBox2 for XE6.
    Can you please send me the link?
    Thanks very much!

  3. Mike Collins says:

    Hi Roman,

    I’ve been searching for an XE 6 version of lockbox 2. I have a lot of legacy code that I need to upgrade to XE 6. I tried to install lockbox 3 but had a lot of problems. I would be extremely greatful if you could send me a link for your lockbox 2 port I would be in depted to you.

    Many thanks in advance

    Mike Collins

  4. Mike Collins says:

    Hi Roman

    Been searching for a while for an XE6 compatible version of lockbox 2. I have a lot of legacy code that I need to migrate over to XE6. I was going to bit the bullet and migrate to lockbox 3 but I couldn’t get it to install.

    I would be most greatful if you could send me a link to your port of lockbox 2.

    Many thanks in advance

    Mike Collins

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.